|
AMGMercedes -> RE: winter foils startup (1/31/2008 10:14:53 AM)
|
I think your best bet would be to first replace the glow plugs with Bosch or an equivilant brand. But not autolite! Then move on to checking each glow plug individually with a multimeter reading OHMs for accurate current. I think they should read '1' or something close. On the glow plug relay there are two connectors, a big one and a smaller one. If you remove the big one and look at the female connector parts, there should be numbers listed next to each hole which represent each cylinder. 1 is the first cylinder glow plug closest to the front bumper, and whatever is the highest number is the cylinder's glowplug that is furthest away from the bumper near the firewall. When all those are tested and have a voltage of '1' then you don't have a short and you can reconnect the plug back into the relay. After that you want to check your glow plug relay fuse, should be a black box on the driver's side mid way. Visually inspect the strip fuse, if it's blown in half or bent, just change it out with a new one. Don't try to bypass it with copper wire or jimmy rig with some material to it because you could fry the entire wiring harness [&:]. Then after the glow plugs are in, the fuse has been checked, the battery is charged and good, I would suggest testing the relay itself. Idk what the relay is supposed to read, but you should be able to find it here or online somewhere. quote:
to check would be the glow plug relay That's a great place to start too, especially if the engine is not turning at all. There's a chance that the relay isn't sending power to the glow plugs at all. Your car should be able to start in any weather. My 190D recently had a starting problem and after fixing it I'm able to start it in 18 degree weather outside. It starts the first try, though it's cold as shit inside the cabin. Too bad the heat doesn't kick in as quickly as the car's engine starts. haha
|
|
|
|