|
digi -> '84 300SD glow plug problem (5/21/2007 10:35:48 AM)
|
My glow plug light began about a month ago not coming on until I intermittedly played the ignition switch on and off several times.
Then it would stay on each time during that cycle until the engine started; but started with difficulty and initial blue exaust.
Have 198K miles on and never had any starting problems..(granted I plugged in if below freezing.)
As of yesterday the light does not come on even with prodding. Very difficult start now unless I preheat (plug in); even at 55 degreesF
.A hot engine always starts well as before.
The strip fuse is fine.
I did an ohm test on the wires in the terminal and got 0 readings on 1 and 5;
and no continuity at all on 2, 3,and 4.
Thanks for any discussiion re this problem.
PDG
|
|
|
|
