Need bolt size for Crank Shaft sensor hold down

Mercedes Benz Forum Mercedes Classifieds Photo Gallery Member List Search Mercedes History Sponsors Contact
Mercedes Benz News Calendars Forum FAQ Mercedes Recalls TSBs Timeslips Register Login

Need bolt size for Crank Shaft sensor hold down

Printable Version

Mercedes >> Mercedes Benz Models >> Mercedes M Class >> Need bolt size for Crank Shaft sensor hold down

Page: [1]

Message

<< Older Topic Newer Topic >>

Need bolt size for Crank Shaft sensor hold down - 9/15/2004 9:16:41 PM

sdanville

Posts: 46
Joined: 8/7/2004
Status: offline

E 10 is too big.
E 8 doesnt seem to fit-
maybe because I have a 3/8 drive and the exterior torx socket is too wide for constricted area.

I ordered a new size 8 with 1/4" drive. But Sure would like to know for certain. If I strip this - - I will be in a world of hurt.

( trying to remove crankshaft position sensor 1999 ML320)

< Message edited by sdanville -- 9/15/2004 9:29:31 PM >

Post #: 1

RE: Need bolt size for Crank Shaft sensor hold down - 9/16/2004 1:46:05 AM

sleepwalker

Posts: 7083
Joined: 4/12/2004
From: Philippine Islands
Status: offline

must be m6X16.

try using the ordinary 1/4 drive socket with 8mm opening.
it snugly fits.

(in reply to sdanville)

Post #: 2

Bolt Size CPS - 9/16/2004 7:53:53 AM

sdanville

Posts: 46
Joined: 8/7/2004
Status: offline

m6X16 means what exactly ?

8mm socket --- You are suggesting using an 8 Torx socket...right ?

THANK YOU VERY MUCH for the reply Mr. Sleepwalker.

Sincerely
Steve Danville

UPDATE: found another post confirming it is an E 8 (external) Torx socket - other post uses just a 1/4" handle.
9/27/2004 ML320 Update. with the right tools it was a breeze to replace the Crankshaft poistion sensor. 1 minute job after you find the bolt. This month I replaced the sensor (that was my cure) and my upgraded fuel filter and lines and Upgraded fuel pump.
My cost. $60, $97, $178.

< Message edited by sdanville -- 9/27/2004 2:43:26 PM >

(in reply to sleepwalker)

Post #: 3