brookings
Posts: 145
Joined: 6/1/2007 Status: offline
|
the switch in question is located where the right top guide pin goes in just above and to the right side side of the right visor. you can see it if you look. to replace, remove the visors and pull straight back on the trim, DO NOT pull down. easy as pie as long as you don''t separate the clips from the trim by pulling down on it. However, you can glue them back on easy enough. $290 seems a bit much for a 1/2 hr job.
< Message edited by brookings -- 6/20/2008 2:05:11 AM >
|