Schnezza
6/25/2008 3:04:34 AM
My drive belt snapped and I need to replace the idler pulley also (top pulley with ribs on it). I loosened the bolt that holds the pulley and it hits the fan when I pull it out. I have spun the fan and there is no gaps between the blades for the bolt to come out. To remove the fan, do I need to remove Radiator, shroud and viscous coupling? The viscous coupling has a large nut. Is this the short cut or does it all have to come out. Or does the I idler support have to be un bolted from the block?
Cheers Schnezza
BLUETEAM
6/25/2008 2:05:49 PM
IT WILL COME BY THE FAN IF YOU HOLD YOUR MOUTH RIGHT. IF NOT THEN JUST TAKE THE LARGE NUT OFF AND THE FAN WILL COME OFF.
